Elenco Rock Driller - Manuel (Page 2)

B. Water Reservoir /
Clamping Plate
Assembly
A. Safety
Switch
Your Rock Driller package should contain the following items:
1. The ROCK DRILLER with drill bit & slide-in WATER RESERVOIR/CLAMPING
PLATE ASSEMBLY,
2. An A/C POWER ADAPTOR,
3. One (1) bag of small, undrilled ROCKS, and
4. One (1) extra DRILL BIT.
5. Jewelry making kit:
• (1) 18” Silver tone necklace chain
• (1) 18” Black leather-like cord necklace
• (3) Key Chains
• (3) Pairs hanging earring wires
• (12) Jump ring connectors
• (1) Glue
POWER CONNECTION
Place the ROCK DRILLER on a level table near an A/C outlet, and plug the A/C
POWER ADAPTER into the Rock Driller’s rear connecting socket. Plug the power
adapter box into a wall socket, and turn the ON-OFF SWITCH to check for
proper operation.
SAFETY FEATURES
Your ROCK DRILLER will not work with the Containment Chamber Door open,
and also will not work if the Water Reservoir isn’t filled to capacity with fresh
water.
ROCK DRILLING PREPARATION
To prepare for drilling a precise hole into a rock:
1. Open the Containment Chamber Door (Fig. 3, A).
2. Slide the Water Reservoir /Clamping Plate Assembly (Fig. 4, B) forward to
release it.
3. Lift the Clamping Plate (Figure 1, A) up and out of the Water Reservoir
(Figure 1,B).
4. Unscrew the Clamping Plate’s two wing nuts (Figure 2, C).
5. Slide the Upper Clamping Plate (Figure 2, A) upward.
6. Select a Rock to drill.
7. Carefully place the rock on the Lower Clamping Plate (Fig. 2, B), centering it
on the raised rubber area.
8. Align both Upper and Lower Plate’s rear notches and pins. Then, slide the
Upper Clamping Plate down onto the Lower Clamping Plate.
9. Re-attach and tighten the Wing Nuts until the rock is securely in place.
10. Slide the Clamping Plate back into the Water Reservoir (Fig. 1, B).
11. Fill the Water Reservoir with water, up to the side wall’s fill mark and just over
the Clamping Plate.
12. Slide the Clamping Plate/Water Reservoir Assembly back into the ROCK
DRILLER (see Fig. 4) and close the Containment Chamber Door until it snaps
into place, which automatically activates the Safety Switch (Fig.4, A).
ROCK DRILLING
Now you are ready to drill a hole through your rock!
Before you begin, CHECK THE ROCK DRILLING BIT, AND BE SURE THE DRILL BIT IS
SCREWED TIGHTLY IN PLACE.
2 3
Figure 1
Water Reservoir/ Clamping Plate Assembly
C. Top Collar A. Clamping
Plate
Assembly
B. Water
Reservoir
Figure 2
Upper & Lower Clamping Plate Exploded View
C. Wing Nuts
Rock
A. Upper
Clamping
Plate
B. Lower
Clamping
Plate
C. Wing Nuts
Figure 3: Rock Driller
B. Lever
C. Drill Bit
D. On-Off Switch
A. Containment
Door
Figure 4 : Water Reservoir Slide-in Procedure