Danby DMW099WDB - Manuel (Page 9)

Installation Guide
1) Make sure that all packing materials are removed from the inside of the microwave oven.
2) Check the microwave for any damage, such as misaligned or bent door, damaged door seals and sealing surface,
broken or loose door hinges and latches, and dents inside the cavity or on the door. If there is any damage, do not
operate the oven but contact a qualified service personnel.
3) This microwave oven must be placed on a flat, stable surface to hold its weight.
4) Do not place the microwave oven where heat, moisture, or high humidity are generated, or near combustible
materials.
5) For correct operation, the microwave oven must have sufficient air flow. Allow 30 cm of space above the microwave
oven,10 cm at back and 7.5 cm at both sides. Do not cover or block any openings on the appliance. Do not remove
the feet on which the microwave oven stands.
6) Do not operate the oven without glass tray, roller support, and shafts in their proper positions.
7) Make sure that the power supply cord is undamaged and does not run under the microwave oven or over any hot or
sharp surfaces.
8) The socket must be readily accessible so that it can be easily unplugged in an emergency.
SPECIAL CORD SET
INSTRUCTIONS DANGER
Electric Shock Hazard: Touching some of the internal components
can cause serious personal injury or death. Do not disassemble
this appliance
WARNING
Electric Shock Hazard: Improper grounding can result in electric
shock. Do not plug into an outlet until appliance is properly
installed and grounded.
Operating Instructions
FEATURES
1) Oven Window: Screen allows cooking to
be viewed while keeping microwave energy
confined in oven.
2) Turntable Shaft
3) Roller Ring
4) Removable Glass Turntable: Turntable
and support must be in place when using
the oven. The turntable may be removed
for cleaning.
5) Control Panel
6) Electronic Display
1
3
2
4
5
6
7