Danby DAC8011E - Manuel (Page 14)

Operating Instructions
USING THE REMOTE
CONTROLLER
BUTTONS
1
ON/OFF MODE
TEMP
UP
TEMP
DOWN
ENERGY
TIMER
CLEAN
AIR
SLEEP
S
SAVER
FAN
TIMER OPERATION
To set the Auto-start time.
1) Push the TIMER button when the unit is
operational, only the Auto-stop feature
can be set.
2) Keep pressing the TIMER button, each
press will increase the selected time by
1 hour increments, up to 12 hours.
3) The time can be set in a range of 0~12
hours.
4) After the desired time has established,
wait for about 10 seconds until the
setting temperature reverts back in the
display window of the air conditioner.
This indicates the program is set.
NOTE:
To cancel the TIMER setting, push the TIMER button until 0 hour is
displayed on the LCD window of the air conditioner.
1
ON/OFF MODE
TEMP
UP
TEMP
DOWN
ENERGY
TIMER
CLEAN
AIR
SLEEP
S
SAVER
FAN
CLEAN AIR OPERATION
When this button is pushed, the ion gener-
ator is energized and will help remove
pollen and impurities from the air. Press it
again to stop the operation.
1
ON/OFF MODE
TEMP
UP
TEMP
DOWN
ENERGY
TIMER
CLEAN
AIR
SLEEP
S
SAVER
FAN
ENERGY SAVER OPERATION
In this mode, the fan will continue to
run for 3 minutes after the compressor
shuts off. The fan then cycles on for 2
minutes at 10 minute intervals until the
room temperature is above the set
temperature, at which time the compressor
turns back on and cooling stars.
13