Danby DWC310BLA - Manuel (Page 5)

1
FEATURES OF YOUR
WINE COOLER
1) Tempered Glass Door: Tinted for UV protection while still
allowing for easy interior viewing.
2) Thermostat Dial: (Externally mounted rear wall thermostat)
For controlling the temperature inside the wine cooler. Turns the
motor (compressor) on /off as soon as the temperature rises/falls
above/below the set cooling level.
3) Magnetic Door Gaskets: Tight fitting seals retain all the
cooling power and humidity levels.
4) Plastic Coated Shelves: Odor resistant, rustproof, and
removable for easy cleaning.
5) Leveling Leg.
6) Interior Light (not shown)
THE CONTROLS OF
YOUR WINE COOLER
OPERATING INTRUCTIONS
2
4
3
4
5
To start the wine cooler, turn the temperature control to the position corresponding to your desired cooling
level. The wine cooler temperature will vary depending on the quantity of bottles stored, and on the frequency
with which the door is opened.
SETTING THE TEMPERATURE:
The temperature of the wine cooler compartment is controlled by adjusting/setting the thermostat control knob,
located on the exterior rear wall of the unit. To start the wine cooler and achieve maximumcooling quickly;
• Turn the temperature control knob clockwise to the furthest (maximum) setting on the darker blue (wide)
section of the graduated control dial.
• Allow the unit to run at this setting for 3-4 hours.
• When maximum cooling is achieved, turn back the temperature control knob setting to the 2 o’clock position
on the graduated blue control dial. See Fig.1.
• To turn off the wine cooler, (no cooling) rotate the control knob to the “0” (off) position. See Fig. 2.
Turn the control to the “OFF” (0) position to temporarily disconnect the cooling cycle. When the wine cooler
is not to be used for long periods of time, disconnect from power and leave the door partially open.
NOTE: Wait 3 to 5 minutes before restarting if operation has been
interrupted.
LIGHT BULB REPLACEMENT:
To replace the interior light bulb;
• Remove the screw holding the light bulb cover, and remove cover.
• Unscrew the light bulb and replace.
NOTE: Light bulb should not exceed 15 watts.
DEFROSTING: Your wine cooler is designed with an “Auto-
Cycle” defrost system.What is Auto Cycle defrost?
The refrigerated surfaces of the fresh food compartment defrost automatically during the “off” cycle of the
cold control (thermostat). Defrost water from the fresh food compartment is disposed of automatically, by
means of being channeled onto a drip tray located on the compressor. Heat transfer from the compressor
causes the defrost water to evaporate.
Fig. 1 Fig. 2