Toa N-8010RS - Manuel (Page 11)

11
6. WIrING
6.1. connection Diagram
1 2 3
To AC mains or a UPS
(Uninterruptible power supply system)* 1
Note
Tips
If there is a danger of lightning strikes,
insert an appropriate surge arrester
into the power line.
Be sure to ground.
3P removable terminal plug
(accessory)
2-core shielded cable
To network
RJ-45 connector
To Line A (orange)
To Line B (brown)
To Line C (black)
RS-140* 2 , RS-150, RS-160,
RS-170, or RS-180
For more information on the RS-140, RS-150, RS-160,
RS-170, and RS-180, please refer to their respective
installation manuals.
16 lines
N-8010RS Substation interface unit
•
• This figure represents the RS-180.
For the RS-140, connection
cable color differs from the
figure above.
* 2
Line A: Brown, Line B: Red,
Line C: Orange
[General description of connection]
For cables, refer to p. 13.
1. Power supply connection
Connect the supplied power supply cord to AC
Mains or a UPS (Uninterruptible power supply).
About power supply cord handling
The supplied power supply cord is designed for
exclusive use with the N-8010RS.
Never use it with other equipment.
2. Substation connections
(Refer to p. 13, "Removable Terminal Plug
Connection.")
3. Network connection
Can be connected to a network of 10BASE-
T/100BASE-TX in auto-sensing.
Use a straight through cable of UTP category 5 or
more for this connection.
* 1 Select an appropriate UPS taking into consideration the total power consumption of all system components
and the required backup time. On-line uninterruptible power supply (UPS) is recommended.
reference
Substation interface unit N-8010RS: 30 W (rated) for CE version, 25 W (rated) for CU version
8-Port 10M/100M Switching Hub: Approx. 10 W (Differs depending on products.)