Toa N-8010EX - Manuel (Page 18)

18
8.4.2. removable terminal plug connection n-8000ex only
step 1. Strip a cable jacket of approx. 7 mm to expose inner cable.
step 2. Loosen the terminal screws and insert the cables.
step 3. Tighten the terminal screws securely.
notes
• Tug lightly on the cable to be sure that it does not pull free. If the cable pulls free, loosen the terminal
screw again and reconnect from step 2.
• Use the screwdriver appropriate to the screws tightened into the terminal plug.
step 4. Insert the wired terminal plug into the terminal block of the N-8000EX.
7 mm
Removable terminal plug
(accessory)
Removable terminal block
N-8000EX rear panel
Tighten 3
4
2
For cables, refer to p. 16, "Type of Cable."
note
Do not solder plate on exposed inner cables when using a stranded wire.