ThermoWorks THERMADATA (RF) WIRELESS TEMPERATURE & DATA LOGGERS - Manuel (Page 4)

SETTING UP THE LOGGER TO LOG TEMPERATURES
• Click the RF ThermaData Logger tab on the software and click the 'Logger Settings' icon in the
'Control' icon group. Enter a name for the logger in the Title (User ID) box.
• Select temperature settings for 'over' or 'under' alarm using the drop-down menu boxes.
• Select the data storage method – 'Stop when full' or 'Overwrite oldest data'.
• Select a 'Start Delay' (note: for immediate start enter 0 hours, 0 minutes).
• Select the logging interval (note: the total time the log will last is shown below the drop-down
box).
• Click the 'Send Settings' button.
• Start the logger by clicking the 'Start button' on the PC screen or using the magnet key fob
(supplied with the base-station) until the LEDs flash.
READING THE TEMPERATURES STORED IN THE LOGGER
• Click the RF ThermaData Logger tab on the software and click the 'New Document' icon in the
'Download' icon group.
TESTING SIGNAL STRENGTH
• Place the ThermaData Loggers in position for the measurements you require.
• Click the RF ThermaData Logger tab on the software and click the 'signal strength' icon in the
'Advanced' icon group. The more green showing in the signal strength bar the better the signal.