Chamberlain 379LMC-10 - Manuel (Page 3)

NOTE: The unit must have an enrolled user before it can be
programmed to the opener. Due to the 30 second time interval,
a second person may be needed to press the “learn” button. If
there is no purple “learn” button refer to Troubleshooting.
1. Press and release the purple “learn” button on the motor unit
of the garage door opener. See illustration above.
2. Open cover and wait for Ready
LED to light.
3. Within 30 seconds of pressing the
“learn” button, slowly and fi rmly
swipe enrolled fi nger.
NOTE: The Retry LED will light if
another swipe is needed.
4. After a passed swipe the Pass
LED will light followed by a lit Send
LED. The opener lights will fl ash.
Programming is complete.
5. If the opener lights don’t fl ash,
press and release the Resend
button at 1 second intervals for up
to 5 seconds until the opener
lights fl ash or the door moves.
Programming is complete.
NOTE: If unit will not program to opener repeat the steps above
or refer to Troubleshooting.
Step 5 Operation
1. Open cover and wait until Ready
LED is lit.
2. Swipe fi nger slowly and fi rmly
down the sensor strip.
3. The Pass LED will fl ash and
garage door will either open or
close.
NOTE: If cover is already open, press either the Resend or the
Enroll button to turn unit on. The Fail or Retry LED will light if
another swipe is needed. If this occurs, swipe slowly and with
more pressure. It may require multiple swipes to get a passed
swipe.
While the door is traveling the Send LED will be lit. During this
time the only way to reverse or stop the door is to press the
Resend button.
Step 4 Program to Opener
ENROLL
FAIL
RETRY
SEND
PASS
READY
ENROLL
ENROLL
FAIL
RETRY
SEND
PASS
READY
ENROLL
ENROLL
FAIL
RETRY
SEND
PASS
READY
ENROLL
ENROLL
FAIL
RETRY
SEND
PASS
READY
ENROLL
1
2
4
3
3
2
5
3