Levana LV-TW301-C - Manuel (Page 8)

8
MOUNTING THE CAMERA
Please be aware of the potential safety hazards associated with power cords
being placed too close to a crib, play area, or other baby sleep environment. Power
cords should NEVER be placed within 3 feet of a crib, or within baby’s reach. Using Levana’s Camera
Setup and Mounting Guide, you can monitor your baby while they sleep safely in their crib.
To Mount on a Tabletop Safely (Figure A):
1. Place the camera on a tabletop no less than 3 feet away from your baby’s crib.
2. Feed the power cord down the back of the table or use wall clips to secure the cord away so
baby cannot reach.
3. Plug in the power cord, check to ensure that you can see your child and there are no viewing
obstructions.
To Mount on a Wall Safely (Figure B-D):
Before drilling a hole, it is important to check the reception and camera positioning in the place that
you intend on hanging it to the wall. Ensure you are hanging the camera no less than 3 feet away
from baby’s crib.
1. Pre-drill a hole in the wall using a 3/16”, 4.8mm drill bit.
2. Insert a wall anchor into the wall and tap gently with a hammer until the anchor is flush with
the wall.
3. Insert a screw into the wall anchor and tighten until the screw only sticks out about 1/2 inch.
4. Plug the power cord into the power jack of the camera.
5. Locate the wall mounting hole on the bottom of the camera (Figure C).
6. Slide the hole over the screw sticking out of the wall (Figure D).
7. Check to see that the monitor is secure, if it is loose you may have to tighten the screw more.
8. Use wall clips to secure the power cord away from the crib or baby’s reach.
D B A C