Levana LV-TW501 - Manuel (Page 12)

12
CAMERA OPERATION
Switching the Camera ON/OFF
Position the camera to view the area you wish to monitor,
angle the camera lens for best view, by turning it up or
down.
1. Slide the power switch to the ON position.
2. The Power LED on the front of the camera will light
up green. The camera is now ready to operate.
3. To turn OFF the camera, flip the power switch
back to the OFF position
↑
Note: If you are using batteries to power the camera unit, and it does not start up when the
power switch is in the ON position, you may need to replace the batteries. The Power
LED will flash slowly when the batteries are low power.
Night Vision
The camera is equipped with four IR (infrared) LEDs. These LEDs, located on the front of the camera,
allow you to see up to ten feet in complete darkness. Allowing you to check your baby at any time
of night.The night vision LEDs will activate automatically when the camera detects that the light
levels are too low.