CompuSTAR 2W900FMR Manuel d'utilisation
Page 5
Page 8
More Button Functions
(1) Time Setting
Tones will sound for confirmation
STEP 1
(II+III)-
2 sec
Button
PressedFor
Function
Time setting is on. The numbers will
flash, and tones will sound.
STEP 2
( I )
(II+ III)-
1/2 sec
Change hour.
Change minutes.
Time setting is off. Tones will
sound.
STEP 3
STEP 4
( I )
( I I )
1/2 sec
1/2 sec
2 sec
(2) RPS & Vibration mode on or off
Note :
Step 2 must be completed within 15 seconds. If not, start over at
step 1.
Tones will sound for confirmation
STEP 1
(II+III)-
2 sec
Button
PressedFor
Function
STEP 2
RPS on or off, tones will sound for
confirmation.
Vibration mode on or off, tones will
sound for confirmation.
( I I I )
( I V )
1/2 sec
1/2 sec
Page 9
Remote-Pager Learn Routine
The CompuStar system will allow up to three remotes to be programmed to one
vehicle. Please perform the following procedure to add or reprogram additional
remotes.
Step1 :
Activate Valet/Programming mode by manually turning the ignition
on and off five times (between Acc and On)
with the key within a 7 second period.
The parking light will flash once with successful
completion of this step.
Step2 :
Within a 7 second period after cycling the ignition for the 5t h time,
press button I. The parking lights will flash once to confirm that the
transmitter has been programmed. You can continue programming
additional remotes. The parking lights will flash two times when the
programming mode has expired.
-
shows the amount of run-time left in the remote
start mode.
Press button
II
for 2 seconds to auto-start an automatic transmission engine.
Remember, that a key in the ignition is required to drive the car.
For manual transmission vehicles, please use reservation mode.
Press button
I I
for 2 seconds in order to turn off an auto-started car.
The engine will run 15 or 25 minutes (25 or 45 min for diesel) depending on preset
options at the time of installation and then shut off.
Auto-Start Function
A n t i - G r i n d
The anti-grind circuit (an optional feature provided by your installer) prevents you
from engaging the starter on a remote-started vehicle.