Chicago Electric 12" COMPOUND SLIDE MITER SAW 96698 - Manuel (Page 15)

Page 15 SKU 96698 For technical questions, please call 1-800-444-3353.
maintenanCe and
SerViCing
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
to preVent
SeriouS injurY
From aCCidental
operation:
turn the power Switch of the
tool to its “oFF” position and
unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
to preVent SeriouS
injurY From tool
Failure: do not use
damaged equipment. if
abnormal noise or vibration
occurs, have the problem
corrected before further use.
Cleaning, maintenance, and
lubrication
BeFore eaCH uSe, 1. inspect the
general condition of the tool. Check
for loose screws, misalignment or
binding of moving parts, cracked or
broken parts, damaged electrical
wiring, and any other condition that
may affect its safe operation.
aFter uSe,
2. clean external surfaces
of the tool with clean, moist cloth.
To prevent accidents, turn off the
tool and disconnect its power supply
after use. Clean, then store the tool
indoors out of children’s reach.
If the blade has become dirty, use a 3.
blade cleaner (not included) to clean
it. Dirty blades will bind more easily,
and will more often overheat and
burn the wood as it cuts. Overheated
blades dull more easily.
If the Blade has become dull, replace it.
4.
Dull blades will cause increased tear-
out and ragged edges on the cuts.
Occasionally clean the Slides,
5.
rotating Table components and other
moving parts. Use a good quality dry
lubricant (not included) which will not
attract dust.
Cover
laser Battery Housing laser Switch
6. To replace the laser Batteries: Lift the
cover off the laser housing. Replace
the batteries with two ‘AAA’ batteries
and close the cover. Caution! to
prevent injury, position batteries in
proper polarity and do not install
batteries of different types, charge
levels, or capacities together.
7. warning! if the supply cord of
this power tool is damaged, it must
be replaced only by a qualified
service technician.
warning