Cuisine-Cookware ZBD6800 - Manuel (Page 8)

8
Status Indicator Lights (indicators vary by model)
The Status display tells you what is happening while the dishwasher is in operation.
The lights will come ON, indicating the sequence of the dishwasher operation.
SENSING Displayed while the ExtraClean ™ Sensor is measuring the amount of soil and
temperature of water. The dishwasher will adjust the selected cycle to achieve
optimal performance.
ADD-A-DISH Displayed during prewash indicating that dishes added now will still be
cleaned.
WASHING Displayed during prewash, main wash and rinse periods.
DRYING Displayed during HEATED DRY.
SANITIZED Displayed when cycle has met sanitization conditions.
CLEAN Displayed when a wash cycle and enhancements are complete.
Time Remaining Display (on some models)
During operation, the display shows the minutes remaining until the cycle is complete. The
display may adjust the remaining time while the Sensing light is on. The time displayed at the
start of each cycle may change from the factory setting as the unit customizes itself to home
use. During a delay start, the display will show hours of time remaining until the cycle starts.
START/RESET
START— After selecting the cycle and desired enhancements, press the START/RESET
pad to ready the dishwasher to begin the cycle. Close the door to start the
cycle or begin the DELAY START countdown. When the cycle starts, the water
fill begins and approximately 60 seconds later the wash action begins.
The dishwasher will always display your last selection and enhancements. If
you don’t want to change the settings, simply press the START/RESET pad to
ready the dishwasher and close the door to begin the cycle.
NOTE:
If the START/RESET light is flashing, the cycle has been
interrupted. Light will stop flashing after the dishwasher automatically
pumps out the water. Close the door to allow the water to pump out (this
takes approximately 70 seconds). When the light stops flashing, the
dishwasher can be reprogrammed and restarted.
Also, if a power failure occurs NORMAL and HEATED DRY will automatically
be programmed. Make any new selections and press the START/RESET pad
to begin the new cycle.
RESET— Open the door slowly to prevent splash-out. Press the START/RESET pad
to cancel the cycle and close the door. Dishwasher will pump out and turn off
after 70 seconds.
NOTE:
If the START/RESET light is flashing, the cycle has been
interrupted. Light will stop flashing after the dishwasher automatically
pumps out the water. Close the door to allow the water to pump out (this
takes approximately 70 seconds). When the light stops flashing, the
dishwasher can be reprogrammed and restarted.
Clean— The CLEAN light is illuminated and a double beep will sound when the
selected cycle and enhancements are complete. You may remove the dishes
at any time. Note the high-efficiency fan will run quietly for 30 minutes to
4 hours (depending on selected cycle) after the CLEAN light is illuminated
to continue drying the dishes. This can be stopped by opening the door
and pressing any keypad.
NOTE:
To turn off the double beep indicator (or re-activate it if it was
previously disengaged), press the HEATED DRY pad 5 times within 3
seconds. A triple beep will sound to indicate the end-of-cycle beep option
has been toggled.
Dishwasher
Control Panel/Operation
7
8
9
10