NEC MultiSync MT810 - Manuel (Page 10)

USERS MANUAL
3 O P E R A T I O N
This section describes how to select a computer or video source and how to adjust the
picture and sound.
General Controls Before you turn on your MultiSync MTS 10 LCD Projector, ensure
that the computer or video source is turned on and that your lens cap is removed.
1. TUm On The LCD Projector The main power switch is on the back panel of the
MultiSync MTS 10 LCD Projector. By turning this switch on, the projector will go
into its standby mode and the power light will glow amber. Only after you press the
"On" button on the remote control or projector cabinet will the power light turn to
green and the projector become ready to use.
NOTE: To turn the LCD projector on and off with just the back panei'switch, use the
menu and enable the "auto start" feature. (See page 57. )
2 .
Select The Computer Or Video Source Press the "Video" (VCR, document
camera, or laser disc player), "S-video", "RGB 1" or "RGB 2" (computer) button
on the remote control to display the image. Or press the "Menu" button on the
cabinet and use the icons to select your video source: "Video", "S-Video", "RGB 1"
or "RGB 2."
3. Adjust The Image Size Press the "Zoom" button (+) or (-) on the remote control or
projector cabinet to make the image larger or smaller.
4. Focus Press the "Focus" button (+) or (-) on the remote control or projector cabinet to
focus the image.
5. Thming Off The Projector First press the "off button on the remote control or the
projector cabinet. The power light will glow amber. Then turn off the main power
switch on the back panel. The power light will go out.
IMPORTANT:
• The LCD projector should be unplugged if it will not to be used for an extended
period.
• Turn off the image briefly (five minutes or less), use the "Picture Mute" button
instead of turning the projector off and on.
• The LCD projector will display a black, blue, or loop image if no RGB input signal
is present. (Not work with video or S-video sources)
• Do not turn the LCD projector off and then immediately back on. The projector needs
to cool for a minute before it can be restarted.
□
OPERATION
3-24