Kenwood KAC-526 - Manuel (Page 8)

Trpi^ie^po^g giiiie
Often, what appears to be a malfunction is due to user error. Before calling for service,
please consult the following table.
Symptom Cause Remedy
No sound.
(No sound from one side.)
Input {or output) cables are
disconnected.
Connect the input
(or output) cables.
The output level is too
small (or too large). The Input sensitivity adjusting
control Is not set to the correct
position.
Adjust the control correctly
referring to 'Controls".
The sound quality is bad.
(The sound is distorted.)
The speakers cable are
connected with wrong @/©
polarity.
Connect them properly checking
the 0/0 of the terminals and
cables well.
A speaker cable is pinched by a
screw in the car body. Connect the speaker cable again
so that it is not pinched by
anything.
Specificaiipnp
Specifications subject to change without notice.
Audio Section
Max Power Output (4 Q)
Normal................................................................................................................................... 70 W x 2
Bridge.....................................................................................................................................200 W x 1
Rated Power Output {4 ii)
Normal..............................................................35 W x 2 (20 Hz ~ 20 kHz, less than 0.08 %THD)
Bridge.................................................................................... ............ 100 Wx 1 (1 kHz, 0.8 % THD)
Rated Power Output (2 Cl)
Normal..................................................................................................50 Wx 2 (1 kHz, 0.8 % THD)
Frequency Response...................................................................................... 10 Hz ~ 45 kHz (+0, -1 dB)
Signal to Noise Ratio................................................................................................. ......................... 100 dB
Sensitivity (MAX)......................................................................................................... 0.15 V (rated output)
Sensitivity (MIN).................... .......................................................................................4.0 V (rated output)
Input Impedance................. ................................................................................................10 kD
General
Operating Voltage..........................................................................................14.4 V (11 - 16 V allowable)
Current Consumption (1 kHz, 10% THD) .........................................................................................(..... 15 A
Dimensions (V\/x H x D)................................................................................................220 x 52 x 160 mm
(8-11/16x2-1/16 X 6-5/16 in.)
Weight............................ ....................................... ..................................................................1.6 kg (3.5 lb)
8 English