Ryobi RY39500 - Manuel

DO NOT squeeze the throttle trigger until the engine starts and runs..
RYOBI ART WORK
Art Part No. : 960091019 Rev. 001
Where Used : 960091019
Refer to Drawings for Dimensions.
960091-019
11-17-09 (REV:01)
Material: 60lb. Stock Paper.
Color: Lift-off Bright Pink.
FRONT
1
3
4
5
6
PRESS and HOLD switch until
engine stops
To Stop:
For any questions about operating or maintaining your product, call the Ryobi Help Line !
Your Product has been fully tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are also available in your operator’s manual.
Go to www.ryobitools.com and register your new tool on-line.
For additional registration instruction, refer to operator’s manual.
CALL
1-800-860-4050
www.ry
obitool
s.com
®
6
1
50:1 Ratio = Mix 2.6 oz 2-cycle lubricant with
1 gallon of fresh gasoline in separate gas
container. SHAKE. Pour into fuel tank.
1 GALLON
GAS
PRIME
press the PRIMER BULB 7 times.
3
x7
PULL
rope until engine starts.
5
2.6
oz.
SET
START lever to " START " position.
4
START
LAY
the TRIMMER on a flat, bare surface.
2
Squeeze throttle trigger lock and throttle trigger.
NOTE: Squeezing and releasing the throttle trigger releases
the start lever to the RUN position
ENGINE STARTING PROCEDURE
WARNING: This Engine Starting Procedure is not a substitute for
reading the operator’s manual. To reduce the risk of injury, user must
read and understand operator’s manual before using this product.