Thetford DC558 - Manuel (Page 4)

Installation Manual 4
Assemble the Enclosure
1. Make sure the enclosure is:
- 42.63 - 42.69 inches high x 23.69 - 23.82 inches wide x 22 inches deep for DC558 models.
2. Make sure the floor is solid and level.
- The floor must be metal or a wood panel and extend the full width and depth of the enclosure.
- The floor must be able to support the weight of the refrigerator and its contents.
3. Make sure there are no adjacent heat sources such as a furnace vent, a hot water heater vent, etc.
4. If there is more than 1/2 inch between either side of the refrigerator and the inside of the enclosure:
- Fill the space with fiberglass (batt-type) insulation or add a baffle to eliminate the clearance.
Put the refrigerator in position (see Art02504)
- Remove the door from the refrigerator (See “Reverse the door swing” section).
- Put screws through the holes of the refrigerator mounting flanges and into the enclosure wall.
- Attach the door to the refrigerator.
Install the Refrigerator
ART 02504
121
121