Setup and adjustments, Warning – Columbian Home Products 540 Manuel d'utilisation

Page 6

Advertising
background image



3

Figure 2

Figure 3

Figure 4

1. Attaching Rear Wheels (If Not Already Attached)

a. Place rear of the mower deck on raised blocks.
b. Remove the hex flanged nut on the rear axle

from each side and place the rear wheel on the
axle. (On select models, these may be included

separately in a plastic bag).

c. On models with 2” wide rear wheels, make sure

the spring washer is on the inside of the wheel
between the wheel and the lawnmower, cupped
side towards the bracket. See Figure 1.

d. Reinsert the flanged nut into

the axle as shown,

and tighten securely. Repeat on other side.

2. Remove loose parts and any packing material which

may be between upper and lower handles.
a. Pull up and back on the upper handle to raise the

handle from position A into the operating position.
See Figure 2.

b. Tighten knobs securing upper handle to lower

handle. Make sure that each carriage bolt is
seated properly in the handle.

3. Locate hairpin clip in one hole on the weld pin on each

side of lower handle.
a. Remove hairpin clip from this hole. Using a pair of

pliers, insert hairpin clip into the other hole on the
weld pin. Repeat on other side. See Figure 3.

b. Place one carriage bolt (found in the hardware

pack included with your unit) in the upper hole of
the right handle mounting bracket from the inside
outward. See Figure 3. Secure with one wing nut.
Repeat process on the left side.

4. Rope guide Setup as follows, see Figure 4:

a. Hold the blade control against the upper handle.

Position A.

b. Slowly pull starter rope out of engine. Position B.
c. Slip starter rope into the rope guide. Position C.
d. Tighten rope guide wing nut (star knobs).Position D.

Figure 1

Disconnect and

ground the spark

plug wire as instruct-

ed in the separate

engine manual.

IMPORTANT

This unit is shipped
WITHOUT GASOLINE
or OIL. After assem-
bly, service engine
with gasoline and
oil as instructed in
the separate engine
manual packed with
your unit.

Make sure to route
cable outside the
lower handle. Do not
crimp cable while
lifting the handle up.

Setup and

Adjustments

WARNING

On models with 2”

wide rear wheels only.

Handle Bracket

B

A

A

B

A

C

D

B

NOTE: The units illustrated may vary slightly from
your unit.

Advertising