Sony TCD-D8 - Manuel (Page 32)

Problem Cause Solution
Noise is heard in the
monitor sound when
recording with an
equipment connected
via the digital
connection.
This is not a malfuntion. (See
page 18).
The volume cannot be
adjusted. The PHONES (AVLS)/LINE
OUT switch is set to LINE OUT. Stop recording/playback or
disconnect the headphones fro
the unit. Then, set the switch ti
PHONES (AVLS).
The PHONES (AVLS)/LINE
OUT switch of this unit is set to
0 AVLS ON. Set the switch to 0 AVLS OFF
The HOLD/PUSH OPEN
switch is set to HOLD. Slide the switch to the center
position.
The clock displays SU/
95Y1M1D/
AM12H00M00S. The batteries are remox'ed from
the unit for one hour or more. Sot the clock again. (See page .a
Neither Start ID nor
PGM number can be
written. The record-protect shutter on
the cassette is open. Close the shutter on the cassetti
(See page 7.)
The Start ID is
written, but the PGM
number is not
written. When recording on a partially
recorded tape, the most recent
PGM number is not displayed
before recording. When recording on a partially
recorded tape, display the PGM
number before commencing
recording.
Operation buttons do
not work while the
Start ID is being
written.
While the Start ID is being
written, none of the buttons
except STOP ■ can be used. Press the buttons after the
hlfJUei'J indicator has stopped
flashing.
Absolute time cannot
be written. Recording has been started
from a blank segment ot the
tape. Rewind the tape to the
beginning, locate the end of the
previous recording and start
recording from that point. (See
page 8.)
The sound picked up
by the microphone is
distorted. The .sound source is too loud. Set MIC SENS switch to L.
Noise occurs during
recording. When monitoring the recording
sound with headphones or
external speakers, they are
placed too close to the
microphone.
Keep tlie microphone away
from them.
The tape stops suddenly
during playback. There is a blank (unrecorded)
part on the tape. —
The cassette
compartment lid
cannot be closed. Power source is disconnected
from the unit while " " or
U P l ! " i*; flashing in the
display.
Connect the power source and
close the lid.
32" Additional Information