Sony DVMC-DA2 - Manuel (Page 9)

Note
Depending on the
condition of the analog
video signal input to the
media converter, some
DV units may not output
the analog video signal
correctly when the digital
video signal is output
from the media converter.
The video recorded on the
DV unit is not affected.
When previewing a
recorded VIDEO ,we
recommend connecting
the input connector of the
TV to the VIDEO OUT or
S VIDEO OUT of the
media converter.
If you want to convert digital video to analog
video
Make the connection as follows:
• Connect the DV output connector of fhe DV unit to
the R DViN/OlXT gonnector of the media converter
using the supplied DV connecting cable.
• Connect the input connectors of the analog video
unit to the AUDIO/VIDEO OUT connectors of the
media converter using the supplied a AV connecting
cable.
Converting analog video to digital
video
You can convert and record pictures and sound from
an analog video unif to a DV unit by connecting both
units via the media converter.
1
Press POWER to turn on the media converter.
2
Press ANALOG IN.
The key indicator lights up.
3
Select the audio mode.
Each time you press and hold ANALOG IN for a
few seconds, the audio mode changes as follows.
16-bit mode (high quality soimd): The key
indicator lights up in red.
12-bit mode (post sound recording): The key
indicator lights up in green.
4
Pause playback on the analog video unit slightly
ahead of the point from which you wanf to start
recording.
5
Pause recording on the DV unit at the point from
which you want to start recording.
Eor details on how to record, refer fo the
instruction manual of your DV unit.
(If you use the SONY DCR-PC1/PC7/PC10, the
remote controller is necessary for recording
operations.)
6
Start playback on the analog video unit, then start
recording on the DV unit.
The picture and soimd played back on the analog
video unit are recorded on the DV unit.
continued