Chicago Electric 97580 - Manuel (Page 13)

SKU 97580 For technical questions, please call 1-800-444-3353. Page 13
troubleshooting
problem possible causes likely solutions
Tool will not start No power at outlet. 1.
Cord not connected. 2.
Carbon Brushes may be worn 3.
or damaged.
Check power at outlet. 1.
Check that cord is plugged in. 2.
Inspect Carbon Brushes and replace if 3.
necessary.
Tool operates
slowly or
sporadically.
Carbon Brushes may be worn 1.
or damaged.
Inspect Carbon Brushes and replace if 1.
necessary.
Tool does not
cut effectively or
blade jams in work
material
Blade may be damaged, worn 1.
or wrong type for the material.
Too much pressure.
2.
Check condition and type of blade. Use only 1.
proper type of blade in good condition.
Ease off pressure on blade.
2.
Follow all safety precautions whenever diagnosing or servicing the
tool. disconnect power supply before service.
Blade selection chart
work material type Blade length tpi Blade material
Wood 6 - 12 inches 5 - 11 Carbon Steel
Wood with embed-
ded nails or screws
6 - 12 inches 11 Carbide tipped Steel (“bi-metal”)
Metal 6 - 9 inches 10 - 25 Carbide tipped Steel (“bi-metal”)
or Carbide Grit
Plastic 6 - 12 inches 9 - 25 Carbon Steel or Carbide Grit
pleAse ReAd tHe Following cAReFullY
THE MANUfACTURER AND/OR DISTRIBUTOR HAS PROvIDED THE PARTS LIST AND ASSEMBLy
DIAgRAM IN THIS MANUAL AS A REfERENCE TOOL ONLy. NEITHER THE MANUfACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS qUALIfIED TO MAkE ANy REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
qUALIfIED TO REPLACE ANy PARTS Of THE PRODUCT. IN fACT, THE MANUfACTURER AND/OR
DISTRIBUTOR ExPRESSLy STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE
UNDERTAkEN By CERTIfIED AND LICENSED TECHNICIANS, AND NOT By THE BUyER. THE BUyER
ASSUMES ALL RISk AND LIABILITy ARISINg OUT Of HIS OR HER REPAIRS TO THE ORIgINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISINg OUT Of HIS OR HER INSTALLATION
Of REPLACEMENT PARTS THERETO.