CCI Thermal Technologies HMK - Hanging Mounting Kit - Manuel

STEP 4
Hang heater from Angle Hangers 
using two 1/2 UNC x 1-1/4 bolts, lock
washers, and nuts.
Hanging Mounting Kit Installation Instructions
For Heater Exchanger Unit Heaters
(En français à l’endos.)
STEP 3
Insert Hanger Assemblies from Step
2 through mounting holes and fasten
using lock washers and 1/2 UNC nuts.
STEP 2
Screw one Connector Hanger  and
one Adaptor Hanger  onto each steel
pipe until tight (minimum of 5 turns
each).
Pipe cut length = Distance from
support structure to top of heater LESS
Connector’s length, 4-7/8” (124mm)
STEP 1
Fasten Angle Hangers  to a
surface or structure that will support the
heater’s weight using the installer
supplied fasteners. Refer to the owner’s
manual for the heater’s weight.
Installer required to supply:
a) a method of fastening the Angle Hangers  to the supporting structure. Four 3/8” diameter, grade 5 bolts are
suggested, however, any method providing the same or greater strength may be used.
b) two pieces of 1/2”, schedule 40 or heavier, steel pipe cut to suit required installation length and threaded at
both ends.
Check that your heater model number corresponds to the model number shown on the mounting kit carton.
WARNING:
If the heater is installed on a structure that is to be transported, provide additional support for
the heater during transit. The suspended weight should not exceed 600lbs (272 kg). Refer to
the owner`s manual for mounting specifications and conditions.
Connector Hanger  must be hung
on the inside of Angle Hanger  as
shown. Rotate Connector Hanger 
to align with Angle Hanger  . Do not
back off more than 3/4 turns.
Part No. 5754-2

Support Structure



Support
Structure
Installer supplied
fasteners
DIM A = Distance between mounting holes.
(Refer to owner’s manual)
4-1/2”
(114mm)



DIM A

1/2” Sch. 40, or heavier
Steel Pipe
CONTENTS
Item Qty.
Description
 2 Angle Hanger
 2 Connector Hanger
 2 Adaptor Hanger
 2 Bolt, 1/2 UNC x 1-1/4
 4 Nut, 1/2 UNC
 4 Lock Washer, 1/2”
Printed in Canada. Copyright 2008. All rights reserved.