Tweco 7-3456 - Manuel (Page 3)

Manual / Manuel 0-2892 3 December 30, 2002 / 30 Decembre, 2002
Installation and Use
1. Press the male connector on the torch leads into the female receptacle on the ATC Adapter. Use the connecting
ring on the torch leads connector to secure the male connector in place in the receptacle. Do not use tools. If
resistance is felt, unthread the connecting ring, check the alignment of the connector and receptacle, and
reassemble.
2. Install the proper torch consumables and set gas pressure according to the Torch Instruction Manual.
3. Connect the RPT Adapter to the Power Supply.
Rotate Connect ing Ring
A-03424
RPT Adapter
ATC Adapter Kit
Torch Lead
Assembly
4. Reconnect main input power to the Power Supply and turn the unit ON.
5. Set air pressure according to directions in the Torch Instruction Manual.
6. Test torch for proper operation.
Connector Pin Layout
Hypertherm powermax 1100
Adapter Pin Layout
(Front View)
Orange/PIP
Green / Switch
Black/ PIP
Negative/
Plasma Lead
Pilot Lead
Alignment
Plug
A-03512
White / Switch
Miller Spectrum 3080 Adapter Pin Layout
(Front View)
Orange/PIP
White/Switch Green/Switch
Black/PIP
Negative/
Plasma Lead
Pilot Lead
Alignment Plug A-03513
NOTE
Every effort has been made to provide complete and accurate information in this manual. However, the
publisher does not assume and hereby disclaims any liability to any party for any loss or damage caused
by errors or omissions in this manual, whether such errors result from negligence, accident or any other
cause.