Tweco 7-3427 - Manuel

Date: September/Septembre 6, 2002 1 Manual/Manuel 0-2760
General Information
This Replacement Torch Adapter Kit is to be used to connect the Thermal Dynamics Plasma RPT Series Cutting Torch
to the following equipment:
• HOBART SMOOTHCUT II 35A, 60A and 100A
Parts Supplied
The following parts are included in this kit:
• Control Connector Plug with Connectors - 1 ea
• Protective Boot - 1 ea
Installation
Install the Adapter Kit per the following procedure:
1. Turn OFF the power supply.
2. Disconnect the main input power to the power supply.
3. Remove the existing torch from the power supply, removing covers as required.
4. Slide the Protective Boot, included in this kit, over the end of the Negative / Plasma Lead.
5. Connect the pilot wire (+) from the replacement torch to the Power Supply and tighten securely. For 35A ma-
chines the pilot wire is not required and must be secured out of the way.
6. Connect the Negative / Plasma Lead from the replacement torch to the Power Supply. Slide the protective boot
over the lead connection.
Manual 0-2760
RPT Adapter Kit
Catalog # 7-3427
Installation Instructions
© 1998 Thermal Dynamics Corp., Printed in USA
82 Benning Street, West Lebanon, NH 03784 USA
(603) 298-5711 • www.thermal-dynamics.com
Torch Control
Connectors
Pilot Lead
Torch Lead Assembly
Negative/Plasma Lead
A-02487
Control Connector
Plug with Connectors
To
Po
we
r Supply
(-) Fitting
To
Po
we
r Supply
Control Connector
To
Po
we
r Supply
Pilot Connector