BIONAIRE PERMAtech BAP1412CN04EFM2 Manuel d'utilisation

Instruction leaflet, Permatech, Please save these instructions

Advertising
background image

BEFORE USE

1. Carefully unpack your air cleaner.

2. Select a firm, level surface with no obstructions to the air

inlets or outlets.

3. If the filter is covered by a bag when shipped, remove

plastic bag before use and place filters into unit (See
INSTALLING THE FILTERS).

OPERATING INSTRUCTIONS

IMPORTANT:

• Remove all plastic bags from filters before use.

• DO NOT POINT FILTERED AIR OUTLET TOWARDS

WALL.

1. Plug into a 120V AC electrical outlet.

2. Select the desired operating speed. Bionaire

®

Air Cleaners

have three speed settings. You can select from HIGH

( )

,

MEDIUM

( )

or LOW

( )

by moving the switch to the

desired setting.

3. To release negative ions into the filtered air, move the ioniz-

er switch to ON ( ) and the light will illuminate.

AIR CLEANER SAFETY

PLEASE READ AND SAVE
THESE IMPORTANT SAFETY
INSTRUCTIONS

When using electrical appliances, basic safety precautions
should always be followed to reduce the risk of fire, electric
shock, and injury to persons, including the following:

Read all instructions before using appliance.

If the filter is covered by a bag when shipped: remove

plastic bag before use.

Keep the cords out of heavy traffic area. To avoid fire

hazard NEVER put cords under rugs, near heat registers,
radiators, stoves or heaters.

To protect against electrical hazards DO NOT immerse in

water or other liquids. Do not use near water.

Close supervision is necessary when any appliance is used

by or near children or disabled persons.

Always unplug the air cleaner before moving it, opening

the grill, changing the filters, or whenever the appliance is
not in use. Be sure to pull by the plug and not the cord.

NEVER drop or insert any object into any openings.

Do not operate any appliance with a damaged cord or

plug, if motor fan fails to rotate, after the appliance
malfunctions, or if it has been dropped or damaged in any
manner. Return appliance to manufacturer for examination,
electrical or mechanical adjustment or repair.

Use appliance only for the intended household use as

described in this manual. Any other use not recommended
by the manufacturer may cause fire, electrical shock or injury
to persons. The use of attachments not recommended or
sold by Jarden Consumer Solutions may cause hazards.

Do not use outdoors.

Never block the air openings, or place on soft surface,

such as bed or sofa, as this could cause the unit to tip
over thus blocking the air intake opening.

Keep appliances away from heated surfaces and open

flames.

DO NOT attempt to repair or adjust any electrical or

mechanical functions on these appliances. Doing so will
void the warranty. The inside of these appliances contain
no user serviceable parts. All servicing should be per-
formed by qualified personnel only.

WARNING: To reduce the risk of fire or electrical shock,

DO NOT use these appliances with any solid-state speed
control device.

DO NOT place anything on top of these appliances.

PLEASE SAVE THESE
INSTRUCTIONS

CONSUMER SAFETY INFORMATION

THIS APPLIANCE HAS A POLARIZED
PLUG (one blade is wider than the other). To
reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact

a qualified electrician to install the proper outlet.

DO NOT DEFEAT THE SAFETY PURPOSE OF THIS
POLARIZED PLUG IN ANY WAY.

The length of the cord used on this product was selected to
reduce the hazards of becoming tangled in, or tripping over a
longer cord. If a longer cord is necessary an approved exten-
sion cord may be used. The electrical rating of the extension
cord must be equal to or greater than the rating of the air
cleaner. Care must be taken to arrange the extension cord
where it cannot be pulled on by children or accidentally
tripped over.

IONIZER

Your Air Cleaner has an independently controlled ionizer, which,
when turned on, releases negative ions into outgoing filtered air.
Ions are tiny particles that carry a positive or negative charge.
These ions exist naturally around us, in the air, water and
ground. Both positive and negative ions are colorless, odorless
and completely harmless.

Negative ions help the air purification process by attaching
themselves to very small airborne particles in the room. These
particles take on a negative charge and may join with positive-
ly charged particles such as dust, pollen, smoke and pet dan-
der to form larger particles that are then more readily captured
by the filter system, or they may be attracted to positively
charged surfaces like walls or floors.

You may also note after extended use, that dust may have
collected around the grills or front panel. This is from the ion-
ization affect caused by the negative ions exiting from the air
outlet. This is additional evidence of the air cleaning effective-
ness of negative ions. The dust can be easily removed with a
clean, damp cloth or soft brush.

NOTE: It is important to clean the filter at the recommend-
ed intervals. Using the ionizer in conjunction with dirty filters
may result in dirty particles exiting the air cleaner and being
attracted to walls, carpets, furniture or other household
objects. These dirty particles may prove very difficult to
remove.

4. For optimum air filtration, it is recommended to operate the

air cleaner continuously. Its rugged motor has been
designed to give many years of use.

For continuous use, it’s recommended to operate the air
cleaner at the MEDIUM ( ) setting. For quieter operation or
use in a bedroom, select the LOW ( ) setting. When high lev-
els of air pollution are present, select the HIGH ( ) setting to
quickly circulate and filter the room air.

CLEANING THE PERMAtech

TM

FILTER

The PERMAtech

TM

filter is designed to never need

replacement. However, we recommend regular cleaning for
optimal performance.

Every few weeks, check the condition of the filter.

After approximately 3 months of operation, the Filter

Indicator Light will alert you to clean the filter before
further use.

TO CLEAN THE FILTER:

1. Turn off and unplug the air cleaner.

2. Remove the air inlet grill by pulling on the tab.

3. Remove and examine the foam pre-filter.

• If it has collected dust or lint, remove and wash it

in warm soapy water. Rinse and drip dry thoroughly
before placing it back into the grill inlet.

4. Check the condition of the PERMAtech

TM

filters and

remove if dirty.

5. Clean the PERMAtech

TM

filter.

• Using your vacuum cleaner, run

the brush attachment along both
sides of the filter and clean
between the pleated layers
(Figure 2).

IMPORTANT: Do not use water, household cleaners or
detergents to clean the PERMAtech

TM

filter.

The filter may appear discolored, even after vacuuming.
This is normal and does not affect performance in any
way—a new filter is not necessary.

If the filter becomes damaged during cleaning, call
1-800-253-2764 to order replacements.

REINSTALLING THE PERMAtech

TM

FILTER AFTER

CLEANING

NOTE: Use hang tab and filter clips to ensure the filter
attaches properly.

1. Make sure the hang tab is securely

in place. Align the clip on the top of
the PERMAtech

TM

filter with the rails

on the inside of the unit. Gently
slide the filter onto the rail
(see Figures 3 and 4).

2. Place air inlet grill back onto unit

securely.

3. Reset the Filter Indicator Light by

inserting a small object (such as a pin
or paperclip) into the hole marked .

TIPS AND TROUBLESHOOTING

LEARNING MORE

For a wealth of information about your air cleaner and other
Bionaire

®

products, visit our website at www.bionaire.com.

PERMAtech

TM

air cleaner

MODEL :

BAP1552-CN

Read instructions before operating.

Retain for future reference.

Instruction Leaflet

INFO-LINE

If after having read this leaflet, you have any

questions or comments on your air cleaner,

call 1-800-253-2764 in North America.

122336/9100040003022

2 YEAR LIMITED WARRANTY

Sunbeam Products, Inc. doing business as Jarden
Consumer Solutions or if in Canada, Sunbeam Corporation
(Canada) Limited doing business as Jarden Consumer
Solutions (collectively “JCS”) warrants that for a period of
two years from the date of purchase, this product will be
free from defects in material and workmanship. JCS, at its
option, will repair or replace this product or any component
of the product found to be defective during the warranty
period. Replacement will be made with a new or
remanufactured product or component. If the product is no
longer available, replacement may be made with a similar
product of equal or greater value. This is your exclusive
warranty. Do NOT attempt to repair or adjust any electrical
or mechanical functions on this product. Doing so will void
this warranty.

This warranty is valid for the original retail purchaser from the
date of initial retail purchase and is not transferable. Keep
the original sales receipt. Proof of purchase is required to
obtain warranty performance. JCS dealers, service centers,
or retail stores selling JCS products do not have the right to
alter, modify or any way change the terms and conditions of
this warranty.

This warranty does not cover normal wear of parts or
damage resulting from any of the following: negligent use or
misuse of the product, use on improper voltage or current,
use contrary to the operating instructions, disassembly,
repair or alteration by anyone other than JCS or an
authorized JCS service center. Further, the warranty does
not cover: Acts of God, such as fire, flood, hurricanes and
tornadoes.

What are the limits on JCS’s Liability?

JCS shall not be liable for any incidental or consequential
damages caused by the breach of any express, implied or
statutory warranty or condition.

Except to the extent prohibited by applicable law, any
implied warranty or condition of merchantability or fitness for
a particular purpose is limited in duration to the duration of
the above warranty.

JCS disclaims all other warranties, conditions or
representations, express, implied, statutory or otherwise.

JCS shall not be liable for any damages of any kind resulting
from the purchase, use or misuse of, or inability to use the
product including incidental, special, consequential or similar
damages or loss of profits, or for any breach of contract,
fundamental or otherwise, or for any claim brought against
purchaser by any other party.

Figure 2

Figure 3

Figure 4

Some provinces, states or jurisdictions do not allow the
exclusion or limitation of incidental or consequential
damages or limitations on how long an implied warranty
lasts, so the above limitations or exclusion may not apply to
you. This warranty gives you specific legal rights, and you
may also have other rights that vary from province to
province, state to state or jurisdiction to jurisdiction.

How to Obtain Warranty Service

In the U.S.A.

If you have any question regarding this warranty or would
like to obtain warranty service, please call 1-800-253-2764
and a convenient service center address will be provided to
you.

In Canada

If you have any question regarding this warranty or would
like to obtain warranty service, please call 1-800-253-2764
and a convenient service center address will be provided to
you.

In the U.S.A., this warranty is offered by Sunbeam Products,
Inc. doing business as Jarden Consumer Solutions located
in Boca Raton, Florida 33431. In Canada, this warranty is
offered by Sunbeam Corporation (Canada) Limited doing
business as Jarden Consumer Solutions, located at 20B
Hereford Street, Brampton, Ontario L6Y 0M1.

PLEASE DO NOT RETURN THIS PRODUCT TO ANY OF
THESE ADDRESSES OR TO THE PLACE OF
PURCHASE.

© 2007 Sunbeam Products, Inc. doing business as Jarden
Consumer Solutions. All Rights Reserved. Distributed by
Sunbeam Products, Inc. doing business as Jarden
Consumer Solutions, Boca Raton, FL 33431.

BAP1552CN07EFM1 Printed in China

• Make sure unit is properly plugged in

and outlet is energized.

• Make sure unit turned ON.

• Remove plastic bag(s) from filter(s).
• Make sure parts are firmly positioned

in place.

• This is normal and does not affect

performance in any way. A new filter
is not necessary.

• Make sure nothing is blocking air inlet

and filtered air outlets.

• Remove all plastic bags from filters.

• Check condition of filters and clean if

necessary.

• Make sure that the air intake grill is at

least 1 to 3 feet from away the wall.

EXCESSIVE
NOISE

PERMAtech

TM

FILTER APPEARS
DIRTY, EVEN AFTER
VACUUMING
CLEAN

DECREASED
AIR FLOW

UNIT WILL NOT
OPERATE

ISSUE

SOLUTION

A

B

F

D

H

C

E

G

I

A.Power Indicator

B.Speed Control

C.Ionizer Control

D.Filter indicator Light

E.Ionizer Light

F. Filtered Air Outlet

G.

PERMAtech

TM

Filter(2)

H.Washable Foam Pre-Filter

I. Inlet Grill

Figure 1

BAP1552CN07EFM1.qxd:BAP1242/1412/1422CN04EFM2.qxd 9/22/07 2:58 PM Page 1

Advertising