Rockwell Automation 2080-PS120-240VAC Micro800 Programmable Controllers External Power Supply - Manuel (Page 6)

6 Micro800™ Programmable Controller External AC Power Supply
Publication 2080-IN001A-EN-P - September 2010
WARNING
• When used in a Class I, Division 2, hazardous location, this equipment
must be mounted in a suitable enclosure with proper wiring method
that complies with the governing electrical codes.
• Any fluctuation in voltage source must be within 85V…264V.
Do not connect the adapter to a power source that has fluctuations
outside of this range.
ATTENTION
• Be careful when stripping wires. Wire fragments that fall into the
controller could cause damage. Once wiring is complete, be sure the
module is free of all metal fragments before removing the protective
debris strip. Failure to remove the strip before operating can cause
overheating.
• Be careful of metal chips when drilling mounting holes for your
controller or other equipment within the enclosure or panel. Drilled
fragments that fall into the controller could cause damage. Do not drill
holes above a mounted controller if the protective debris strips have
been removed.
• Electrostatic discharge can damage semiconductor devices inside the
adapter. Do not touch the connector pins or other sensitive areas.
• Mount the power supply vertically.
Allow 50 mm (2 in.) of space on all but the right side for adequate
ventilation.
• Do not wire more than 2 conductors on any single terminal.