Black & Decker CM5050C - Manuel (Page 4)

6 7
How to Use
This product is for household use only.
GETTING STARTED
• Remove all packing material and any stickers from the product.
• Remove and save these instructions.
• Please go to www.prodprotect.com/applica to register your warranty.
• Wash all removable parts as instructed in CARE AND CLEANING section of this manual.
• Open one-piece cover and pour fresh cold water into the water
reservoir up to 12-cup (MAX) mark (B).
• Place permanent nylon filter or paper 8 – 12 cup basket-style
paper filter into filter basket holder (C).
• Close one-piece cover.
• Make sure the lid of the carafe is in place and place empty
carafe on the “Keep Hot” carafe plate.
• Pull power cord out of the cord storage in the back of
coffeemaker and plug into an outlet.
• Brew water through appliance following the BREWING COFFEE
instructions – without adding coffee grounds.
Note: This removes any dust or residue that may remain in the system during the
manufacturing process.
• Discard water from the carafe; rinse permanent filter or discard paper filter, if used.
• Turn off the appliance, unplug it and allow to cool down.
ADJUSTING THE POWER CORD LENGTH
Note: You can adjust the length of the power cord to suit your needs.
• To increase the length of the power cord, simply grasp the cord
(not the plug) in the rear of the coffeemaker and gently pull
down and out of the slot away from the coffeemaker (D).
• To decrease the length of the power cord, simply feed any
excess cord into the slot in the rear of the coffeemaker.
WATER FILTER
1. Remove carbon filter from packing material.
2. Press latch on filter holder to open (E).
3. Place carbon filter inside.
ENGLISH
D
4. Close the filter holder tightly until it snaps into place (F).
5. Place filter holder inside the water reservoir and insert it
into the recess at the bottom right hand corner (G).
Note: Replace carbon filter every 60 brewing cycles or every
2 months after removing it from the sealed package. Call the
800 number on the front cover for replacements
WATER FILTER REPLACEMENT
1. Press latch on filter holder to open (see illustration E).
2. dispose of old carbon filter.
3. Remove new carbon filter from packing material.
4. Place new carbon filter inside filter holder.
5. Close the filter holder tightly until it snaps into place (see illustration F).
6. Place filter holder inside the water reservoir and insert it into the recess at the
bottom right hand corner (see illustration G).
Note: Replace carbon filter every 60 brewing cycles or every 2 months after removing
it from the sealed package. Call the 800 number on the front cover for replacements.
SETTING THE CLOCK
1. Plug appliance into standard electrical outlet.
2. The digital clock display flashes 12:00.
Note: You must set the clock in order to use the DELAYED BREWING feature.
3. To change the time: Press HoUR button until the correct
time appears (H).
Note: When the time passes noon the letters “PM” will appear
in the lower right corner of the display to let you know you are
in P.M. time. If the PM is not shown in the display, the time is
AM.
4. Repeat with the minute (MIN) button.
Tip: Hold the buttons down to make the hours and minutes change rapidly after a short
delay. To change the time in 1-hour or 1-minute increments, tap the button.
Note: If the appliance is unplugged or power is interrupted even momentarily, the time
may need to be reset.
B
C
H
E
F
G