Summit SCR1400W - Manuel (Page 7)

7
INSTALLATION INSTRUCTIONS
BEFORE USING YOUR APPLIANCE
• Remove the exterior and interior packing.
• Before connecting the appliance to the power source, let it stand upright for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• Install the handle on the door. (See page 9.)
INSTALLATION OF YOUR APPLIANCE
• The appliance is designed for built-in or free-standing installation for SCR1536B and free-standing
installation only for SCR1155W, SCR1400W and SCR1005W.
• WARNING: Do not store or install the appliance outdoors.
• Place your Beverage Merchandiser on a floor that is strong enough to support it when it is fully loaded.
To level the unit, adjust the front leveling legs.
• For freestanding installation, a clearance of at least 5 inches (127mm) of space for the back and sides
of the unit is suggested, which allows the proper air circulation to cool the compressor and condenser
for energy savings. For built-in installation, you must allow at least ¼” (6.35mm) of clearance on each
side, 1/16” (2mm) at the top and 2” (50mm) at the back to ensure proper service access and
ventilation. The air vent at the front of the appliance must never be covered or blocked in any way.
• NOTE: It is recommended that you do not install the appliance near an oven, radiator or other heating
source. Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Don’t install in a location where the temperature will fall below 60°F (16°C). For best
performance, do not install the appliance behind a cabinet door or block the base grille.
• Avoid locating the unit in moist areas.
• Plug the Beverage Cooler into an exclusive, properly grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning
power and/or grounding should be directed toward a certified electrician or an authorized service
center.
ELECTRICAL CONNECTION
This appliance should be properly grounded for your safety. The power cord of this appliance is equipped
with a three-prong plug which mates with standard three-prong wall outlets to minimize the possibility of
electrical shock.
Do not under any circumstances cut or remove the third (ground) prong from the power cord supplied. For
personal safety, this appliance must be properly grounded.
This appliance requires a standard 115/120 Volt AC ~ 60Hz three-prong grounded electrical outlet. Have
the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.
When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.
WARNING
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by a qualified electrician or an authorized service center.