SPYPOINT C4 - Manuel (Page 5)

8 9
English
English
MODE
When the « PHOTO » or « VIDEO » mode is selected, the
test light in the front of the camera flashes for 60 seconds to
allow the user to leave without being photographed or filmed.
When the « SET/TEST » mode is selected, no picture or video
is recorded.
Walk perpendicularly in front of the camera. When
the camera detects movement, the light winks to indicate that
normally, a photo or video would be recorded.
If the system does
not detect the movement, increase the distance detection using the
wheel
« DISTANCE » or realign the system differently. When you
understand how the device responds to detections, you can better
adjust the direction or the height of the installation.
When the
switch is set to « VIEW », you can view the recorded pictures
or videos on television.
How to properly install your camera
using the supplied installation strap:
(Recommanded installation height: about 3 feet).
10_5
10 sec. delay 1 min. delay
DELAY
To select the time interval before the camera records another
photo or video.
Additional setting: it is possible to decrease the delay between
detections to 10 seconds (instead of 1 minute) by using the
following procedure. Note that the battery life will be
affected.
Turn OFF the camera. Press and hold the « UP » button, turn
the camera on. « 10_S » appears on the screen meaning the
1 minute delay has been replaced by a 10 second delay. To
reset the camera to 1 minute delay, follow the same procedure.
« 1_M » appears on the screen (see figure below).
MULTI-SHOT
To take up to 4 consecutive shots at each detection. The delay
between each photo is 10 seconds with the infrared module and
15 seconds with the flash module. This option is available in
« PHOTO » mode only.
VIDEO LENGTH
Allows you to select the recording duration when the camera is
set in « VIDEO » mode.