Orbit Baby Bassinet Cradle G2 - Manuel (Page 13)

Manual Text Booklet - Orbit Baby Bassinet Cradle G2 - ENGLISH - 7
Getting Started
Remove all the parts from the box. You should have received a bassinet, rocker hub, and two (2)
rocker tubes. These parts are illustrated in your manual foldout.
 assemble the bassinet
⃞ Remove the bassinet cover Ⓑ by pulling the two plastic grommets Ⓒ and two elastic loops off of
the bassinet posts Ⓔ.
⃞ Pull back the upholstery Ⓕ at the foot end of the bassinet.
⃞ Pull on the webbing loop Ⓠ on the interior of the bassinet to move the black metal bar Ⓟ into
position under the plastic clips. It may help to move the webbing loop to one corner of the metal
bar and pull it into place and then move the loop to the other corner to pull it into place.
⃞ Repeat this process at the head end of the bassinet by pulling back the upholstery and using the
webbing loop to pull the black metal bar into place. After both bars are locked in place, replace the
upholstery and sunshade Ⓐ onto the bassinet frame.
 Install the cover (optional)
⃞ Stretch the foot end of the bassinet cover Ⓑ over the foot end of the bassinet.
⃞ Attach the two plastic grommets Ⓒ and elastic loops of the cover onto the bassinet posts Ⓔ.
⚠
WarNING
⚠
◦
Rocker must be properly assembled before use.
 assemble the rocker
⃞ Insert the rocker tubes Ⓗ into the rocker SmartHub Ⓖ.
⃞ Ensure that all four rocker snap buttons are locked in place.
assembly of the Orbit Baby Bassinet Cradle G2 is now complete.