MARVEL Scientific 6CRDE - Manuel (Page 4)

INSTALLING YOUR REFRIGERATED DRAWERS
Select Location
The proper location will ensure peak performance of your
appliance. We recommend a location where the unit will
be out of direct sunlight and away from heat sources. To
assure your product performs to specifications the recom-
mended installation location temperature range is from 55
to 100°F (13 to 38°C).
Cabinet Clearance
Ventilation is required from the bottom front section of the
unit. Keep this area open and clear of any obstructions.
Adjacent cabinets and counter top can be installed around
the unit as long as the grille and drawer access remain
unobstructed.
Front
Leveling Legs
Front Grille,
keep this
area open.
Figure 2
4
Front Grille
Do not obstruct the front grill. The openings within the front
grill allow air to flow through the condenser heat exchanger.
Restrictions to this air flow will result in increased energy
usage and loss of cooling capacity. For this reason it is im-
portant this area to not be obstructed and the grill openings
kept clean. AGA MARVEL does not recommend the use of
custom made grills as air flow may be restricted because of
inadequate openings. (See Figure 2).
Rear
Leveling
Leg
Front grille screw
Figure 3
Front Grille (Toe kick)
Leveling Legs
Adjustable legs at the front and rear corners of the unit
should be set so the unit is firmly positioned on the floor
and level from side to side and front to back. The overall
height of your Marvel refrigerator may be adjusted from
33 3 ⁄
4
" (85.7cm) with the leveling legs retracted, and up to
34 3 ⁄
4
" (88.3cm) with the leveling legs extended. (See Figure
2).
To adjust the leveling legs, place the refrigerator on a solid
surface and protect the floor beneath the legs to avoid
scratching the floor. With the assistance of another person,
lean the refrigerator back to access the front leveling legs.
Raise or lower the legs to the required dimension by turn-
ing the legs. Repeat this process for the rear by tilting the
refrigerator forward using caution to prevent the door from
opening. On a level surface check the refrigerator for level-
ness and adjust accordingly.
The front grille screws may be loosened and the front grille
adjusted to the desired height. When adjustment is com-
plete tighten the two front grille screws. (See Figure 3).