Bissell 82G7S - Manuel (Page 6)

Attach vacuum hose and tools
1. Line up the tabs on the base of the Twist ‘n
Snap hose with the corresponding notches
on the hose collar as shown.
2. Turn the Twist ‘n Snap hose to the left
to lock the hose into place.
3. Connect the curved hose wand to the hose.
Grasping the curved hose wand, slide the
end of the curved hose wand onto the hose
wand base. Snap the hose into the hose clip.
NOTE: The vacuum will not operate effectively
unless the curved hose wand is firmly attached.
4. Slide the extension wand and crevice tool
together into the storage clip.
5. Slide the dusting brush/upholstery tool into
the storage clip.
6. Store TurboBrush on the front of the handle
by lining up the TurboBrush base with the
base of the holder then push back to snap
into place.
Power switch
The power switch is located just below the
handle on the front of the vacuum. Push the
rocker switch “ON” (I) to vacuum, and “OFF” (O)
when cleaning is complete.
A
ssembly
6
w w w . b i s s e l l . c a 1 - 8 0 0 - 2 6 3 - 2 5 3 5
NOTICE:
For above floor cleaning, the floor
brush will continue to rotate but
is raised above floor. To prevent
carpet damage, do not lean on
the vacuum or let the powerfoot
tilt forward.
CAUTION:
To avoid personal injury
and to prevent the cleaner
from falling when cleaning
stairs, always place it at
the bottom of the stairs.
O
peration
CAUTION:
Before using your vacuum,
make sure that the dirt
container is in the locked
position and that all filters
(pre-motor and hEPA post-
motor) are in place. Do not
operate your vacuum
without these filters.
1.
Twist 'n
Snap
Hose 6.
DJ68-00375P (EN)-0.1.indd 6 09. 12. 03 �� 9:16