Whirlpool XHP1550VW - Manuel (Page 7)

7
When the washer/dryer is level, use a 9/16" open-end wrench
to securely tighten all four jam nuts against the pedestal.
ImPoRtant: The jam nuts must be tightened to avoid
vibration.
Pull both drawer slides out and reassemble the drawer to the
drawer slides with the two hex-head screws.
Remove the divider from the bag. Place the divider in the
drawer at the desired location. Close the drawer.
note: Use of the divider is optional.
Locate the 1/4" hex-head screws on the top of each pedestal
foot. Reach inside the pedestal and use a 1/4" hex-head
ratchet or open-end wrench to adjust the feet up or down
as needed, to level the washer/dryer.
note: Make sure all four pedestal feet are in solid contact
with the floor.
12.
adjust pedestal feet
13.
securely tighten jam nuts
15.
Place drawer divider
Hex-head screw
Drawer slide
14.
Reassemble pedestal drawer
Place a level on top edges of washer/dryer, checking each
side and front. Rock washer/dryer back and forth to make sure
all four feet make solid contact with floor.
If not level, adjust pedestal feet up or down, repeating as
necessary.
11.
Check levelness of washer/dryer
Not Level level Not Level
Place level here