Whirlpool WMC10007AW - Manuel (Page 4)

4
Mark and Drill Holes
1. Mark the four hole centers through the template onto the
lower shelf of the cabinet.
2. Remove the template.
Following are the dimensions for the mounting holes on
Template A:
3. Using 1/2" drill, drill four holes through the centers marked in
Step 1.
4. Place the four C-washers near the holes inside the cabinet.
Install the Microwave Oven
1. Remove the plugs from the four mounting holes on the top of
the microwave oven. Save the plugs in case the microwave
oven is used as a countertop unit in the future.
A. Plugs (4)
2. Start the four bolts into the mounting holes. Turn each bolt
three or four times.
3. If the front edge of the cabinet is flush with the bottom of the
cabinet (if there is no “lip” or trim overhang that extends below
the cabinet bottom), proceed to Step 7.
4. If the front edge of the cabinet has a “lip” or trim overhang that
extends below the bottom of the cabinet, measure the length
of the overhang. Spacers may need to be used on the back
bolts.
5. Determine the number of spacers needed for the back bolts.
6. Place the appropriate number of spacers on the back bolts.
¹⁄₂
" (13 mm)
diam.
5
¹¹⁄₁₆
"
(14.4 cm)
5
¹¹⁄₁₆
"
(14.4 cm)
4 ⁵⁄₁₆
"
(10.9 cm)
7 ³⁄₄
" (19.8 cm)
3"
(7.6 cm)
1
⁹⁄₁₆
"
(4.0 cm)
8
¹¹⁄₁₆
"
(22.0 cm)
7
¹⁄₄
"
(18.4 cm)
Cabinet front edge
Center of
installation
space
12
¹⁄₁₆
" (30.7 cm)
A. Cabinet
B. Trim overhang
If the trim overhang is: Use:
less than 1/2" (13 mm)
1/2"-3/4" (13-19 mm)
3/4"-1" (19-25 mm) 0, 1 or 2 spacers
2 or 3 spacers
3 or 4 spacers
A
A
B