Pioneer PDX-Z9 - Manuel (Page 38)

Additional information 10
38
En
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with
this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other
components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks
listed below, ask your nearest Pioneer authorized service center or your dealer to carry out repair work.
• If the unit does not operate normally due to external effects such as static electricity disconnect the power plug
from the outlet and insert again to return to normal operating conditions.
General
SACD/CD
Problem Remedy
Power can’t be turned on, or
power suddenly turns off by
itself. (In some cases, the
green
TIMER indicator may
flash, and when power is
turned on again an error
message may appear in the
display.)
• Without disconnecting the power cord, wait for one minute and then try pressing the
STANDBY/ON button to turn power on again.
• A speaker cable may be short circuited. Remove the speaker cables, securely twist the
cores of the wires, and once again connect the wires properly to their speaker terminals.
• Overheating may have been caused by lack of sufficient air space around the unit. Install
the unit so as to allow sufficient ventilation around all sides.
• Try lowering the volume level when using the unit.
If none of these remedies works, call a Pioneer-authorized independent service company.
No sound, or sound is
distorted. • Check that the disc is not damaged, and free from dust and dirt (page 36).
• Check that all interconnects are firmly inserted.
• Check that the plugs and terminals are free of dirt, oxide, etc. and clean if necessary. Also
check the cable for damage.
• Make sure the audio component’s output is not connected to the receiver’s phono
(turntable) inputs.
• Check receiver’s settings (volume, input function, etc.).
• Make sure the component is connected correctly (refer to
Connecting audio components
on page 9).
• Press
MUTE on the remote control to turn muting off.
Noise during playback of a
cassette deck. • Move the cassette deck further from your receiver, until the noise disappears.
The remote control doesn’t
seem to work. • The remote control is too far from the receiver, or the angle with the remote sensor is too
wide: Use the remote within its operating range (page 6).
• The battery is exhausted: Replace the batteries (page 6).
Problem Remedy
The disc won’t play or is
automatically ejected after
loading. • Make sure the disc is free from dirt and dust and is not damaged (page 36).
• Check
Disc / content format playback compatibility on page 7 to confirm that the disc is
compatible with this receiver.
• Make sure the disc is loaded with the label side face-up and aligned properly in the disc
tray guide.
• Condensation inside the receiver: Allow time for condensation to evaporate. Avoid using
the receiver near an air-conditioning unit.
Noticeable difference in SACD
and CD volume. • This is due to differences in the audio format and is not a malfunction.
Cannot play multichannel
audio. • This receiver is not compatible with multichannel audio.
PDX-Z9.book 38 ページ ２００８年２月２６日 火曜日 午後６時３２分