Trademark Tools Wall Mount Electric Fire Place with Remote Control - Manuel (Page 7)

7
Important Safety Instructions
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ
CAREFULLY AND RETAINED FOR FUTURE REFERENCE
screws and lift off the lamp cover.
For access to the bottom bulbs, carefully slide the flexible rotisserie to one side ensuring that the rubber
grommet is not lost — see Fig.6.
Remove the light screen fixed by two screws — see Fig.7.
Remove the defective bulb by pulling it out of the holder.
Replace with a 40W G9 halogen bulb. Take care not to touch the bulb with bare hands and ensure that
the bulb is pushed home.
Refit the light screen.
Refit the rotisserie making sure that the rubber grommet is carefully pushed into the slotted hole on the
axial bracket.
Refit the lamp cover.
Lift the fire back onto the wall and replace the glass front by lifting onto the lugs either side of the fire.
Cleaning
WARNING! Always disconnect from the power supply before cleaning heater
For general cleaning use a soft clean duster-never use abrasive cleaners. The glass viewing screen should
be cleaned carefully with a soft cloth. DO NOT use proprietary glass cleaners.
Technical Specification
Supply: 110-120V~ 60Hz
Rated power: 1500W
Lighting: Max 40W G9 halogen bulb