Nyrius RF Modulator - Manuel (Page 6)

- 6 -
1. After connection, slide the power switch to the ON position to turn the modulator ON.
2. By default, the modulator is set to CATV mode, if this is the proper TV mode then you can choose
a channel at this point.
3. You can select the channel by pressing the CH + and CH- buttons on the front of the modulator,
the current channel will be displayed on the LED display.
4. If CATV is not the right mode, follow the “Changing Modes” directions and then choose the
channel using the same method in step 3.
5. Choose an unused channel for best operation and the least amount of interference.
Channel
Display
Channel Up and
Down Buttons
OPERATION