NaceCare Solutions TTB1620 - Manuel (Page 16)

16
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS
! !
Fitting the floor-tool
Lower the floor-tool arm by moving the release lever to the lower position (fig. 4)
Push floor-tool onto the holder and secure with the easy-fit securing pin (fig 5)
Push waste collection pipe onto the floor-tool; ensure a tight fit (fig 6)
Note: Raise floor-tool again before moving the machine to the cleaning area (fig.7)
!
Fig.5
Fig.7
Fig.6
Fig.4
Machine Set Up
Fitting the brush
Featuring the new OBS (Octagonal Brush System);
The brushes simply push-fit up onto the chucks making fitting and removal a simple process.
Slide the brush under the brush deck (fig 8).
Fit the brush onto the OBS drive chuck (fig.9)
Safety gloves are recommended for the changing of used brushes.
Fig.8
Fig.9
20” Brush or a 20” Pad on the TTB 1620.