NaceCare Solutions TTB1120 - Manuel (Page 8)

8
Using the handle position lever
(Fig.1), move the handle into the
upright position (Fig.2).
PlEASE READ bEFORE COMMENCING ANy OPERATION.
After the removal of all the packaging, carefully open and check the contents.
Ensure the Batteries are charged before use.
! !
1
4
5
Fit the isolator key and switch the machine on (Fig.7).
Fig.1
Quick Set-Up Guide
2 Place 50 amp fuse (supplied in the accessory kit) into the fuse holder using
the Maxi Fuse puller provided (Fig.3).
(Fig.4) Shows 50 amp fuse.
Fig.3
Place the top tank (waste water) into the machine (Fig.5) and connect the
vacuum and floor tool hose to the separator (Fig.6). 3
Fig.5
Fill the bottom tank (Clean Water) from a tap or hose pipe using the Flexi-Fill pipe fitted to
the filler cap (Fig.8). Add non-foaming cleaning fluid as required (see page 11).
The TTB 1117 and the TTB 1120 both have a water capacity of 11 gal.
Fig.2
Fig.4
Fig.6
Fig.7
Fig.8
Note:
Great care must be taken to ensure that contaminants
(leaves, hair, dirt, etc.) are not allowed to enter the
clean-water tank during the filling process.
If using a bucket or similar, ensure it is always clean
and free from debris.