NaceCare Solutions TT516 - Manuel (Page 15)

15
Only use brushes provided with the appliance or those specified in the instruction manual.
The use of other brushes may impair safety.
A full range of brushes and accessories are available for this product.
Only use brushes or pads which are suitable for the correct operation of the machine for the specific task being
performed.
It is essential that this equipment is correctly assembled and operated in accordance with current safety regulations.
When using the equipment always ensure that all necessary precautions are taken to guarantee the safety of the
operator and any other persons who may be affected.
Wear non-slip footwear when scrubbing. Use a respiratory mask in dusty environments.
When cleaning, servicing or maintaining the machine, replacing parts or converting to another function the power
source shall be switched off.
Mains operated machines shall be disconnected by removing the power plug, and battery operated machines shall be
disconnected by switching off the isolating key.
Machines left unattended shall be secured against unintentional movement.
Operators shall be adequately instructed as to the correct use of the machine.
When detergents or other liquids are used, read the manufacturer’s instructions.
Do not allow the supply cord to come into contact with the rotating brushes.
WARNING
Data
Brush Motor Vac Motor Power Noise Speed Brush Dimensions
400 W 300 W 120v 60Hz 71 dB(A) 50Hz = 150rpm 16” Width - 20.5”
Length - 35”
Height - 44.6”
Gross Weight
Full
Protection Class Hand Arm
Vibration
Pad Net Weight Cleaning
Range
Water Capacity
122.6 lbs IPX 4 1.4 +/- 0.06ms² 16” 85 lbs 42 m 5 gall
Fluid Flow
tap @40 0
Brush / Pad
Pressure
Cleaning Speed
0.35 LPM 27.4 / 26.2
G/ cm 2
0 - 2.6 mph
TT 516
PROBLEM CAUSE SOLUTION
Poor water pick-up Waste-water tank full
Clogged / blocked vacuum hose
Loose hose connections
Debris basket filter clogged/blocked
Separator filter clogged / blocked
Poor separator seal
Damaged separator seal
Damaged / split vacuum hose
Damaged floor-tool blades Empty waste-water tank
Remove and clean
Push tight connections
Remove and clean
Remove and clean
Clean and refit
Renew (contact service dept)
Renew (contact service dept)
Renew (contact service dept)
No brush / scrub function No brushes fitted Check and fit
Little or no water flow Clean-water tank empty
Clean-water tank filter blocked/ clogged Fill clean-water tank
Remove and clean
Trouble-Shooting