Napoleon Fireplaces EFL100 - Manuel (Page 16)

W415-1140 / A / 07.04.13
16
EN
9.0 TROUBLE SHOOTING
!
WARNING
42.28
SYMPTOM PROBLEM TEST SOLUTION
Dim or no fl ame LED’s are burnt out Inspect the LED’s beneath the fl ame generation belt and re-
place them if necessary
Appliance turns off
and will not turn on Appliance has overheated
and safety device has
caused the thermal switch to
disconnect Unplug the appliance, allow appliance to cool for 15 minutes,
then plug it back in
House circuit breaker has
tripped Reset house circuit breaker
Appliance will not
come on when
switch is fl ipped to
ON Appliance is not plugged
into an electrical outlet Check plug and plug it in
Appliance has overheated
and safety device has
caused the thermal switch to
disconnect Unplug the appliance, allow appliance to cool for 15 minutes,
then plug it back in
Remote control
does not work Low batteries Replace batteries in remote control
TURN OFF THE APPLIANCE COMPLETELY AND LET COOL BEFORE SERVICING. ONLY A
QUALIFIED SERVICE PERSON SHOULD SERVICE AND REPAIR THIS ELECTRIC APPLIANCE.
SYMPTOM PROBLEM TEST SOLUTION
Flame belt is not
operational Belt has become
disengaged Remove belt, check for obstructions, repair any damages and
reinstall the belt
Belt has broken Replace the broken belt
Motor does not work Replace the broken motor