Napoleon Fireplaces EF30G - Manuel (Page 14)

W415-0760 / C / 12.21.11
14
A hearth is NOT necessary but is recommended for aesthetic purposes.
IT IS MANDATORY TO HAVE AN INSULATED WALL BEHIND THE APPLIANCE, WHEN THE
APPLIANCE IS BEING INSTALLED ON AN OUTSIDE WALL OR CHASE.
5.0 FINISHING
5.1 HEARTH
5.2 COLD CLIMATE INSTALLATION
!
WARNING
A. Power supply service must be completed prior to fi nishing to avoid reconstruction.
B. Appliance vents and air openings cannot be covered in any circumstances.
5.3 FINISHING CHECKLIST
RISK OF FIRE!
NEVER OBSTRUCT THE FRONT OPENING OF THE APPLIANCE.
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
REMOVED, CRACKED, BROKEN OR SCRATCHED.
FACING AND/OR FINISHING MATERIAL MUST NEVER OVERHANG INTO THE APPLIANCE OPENING.
!
WARNING
BOTTOM TRAY
2 SCREWS
GLASS
FRONT
5.4 GLASS EMBER INSTALLATION
!
WARNING
GLASS FRONT MUST BE REMOVED AND THE APPLIANCE MUST BE INSTALLED IN IT’S FINAL
LOCATION BEFORE THE GLASS MEDIA IS INSTALLED.
GLASS MEDIA MAY HAVE SHARP EDGES, WEAR SAFETY GLASSES AND GLOVES WHEN
HANDLING.
CLEAN THE GLASS MEDIA PRIOR TO INSTALLATION. BEFORE APPLYING THE CLEANED GLASS,
ENSURE THAT IT IS DRY.
DO NOT CHANGE OR SUBSTITUTE THE GLASS MEDIA MATERIAL PROVIDED WITH THIS
APPLIANCE. IF REPLACING, USE ONLY THE REPLACEMENT GLASS MEDIA AVAILABLE FROM
YOUR AUTHORIZED DEALER / DISTRIBUTOR.
A. To remove the glass front, remove the two bottom
screws as illustrated below.
B. Lift the front up and pull forward and off. Set the front
in a location where it will not be knocked over or
damaged.
C. Carefully distribute the glass embers into the bottom
tray on the front of the appliance as illustrated.
NOTE: Glass media may have a fi ne oil residu
ethat needs to be cleaned prior to installation.
Clean the glass with mild dish soap, drain,rinse
thoroughly and dry before placing it in theappli
ance
D.
Re-install the glass front using the two securing
screws.