Napoleon Fireplaces Napoleon 50 - Manuel (Page 13)

EN
W415-1223 / A / 01.11.14
13
5.0 OPERATING INSTRUCTIONS
Once the appliance has been plugged into a grounded electrical outlet, it is ready to operate.
NOTE: Ensure the house circuit breakers for the power supply are turned on. In the event of a power
failure, when the main power switch of the appliance is in the "I" ON position and the hand held remote
control is in the OFF position, the fl ame generation lights will come back on at the high setting, when
the power supply returns.
The Main Power Switch is located on the bottom right side of the appliance as illustrated.
The "|" indicates ON and "O" indicates OFF. Push the switch to "|" to turn
on the appliance and the fl ame effect.
5.1 MAIN POWER SWITCH
NOTE: Make certain new batteries are installed correctly.
A. Plug in your electric appliance.
B. Make certain the appliance’s Main Power Switch is at the ON position! The remote control will NOT
work if the Main Power Switch is at the OFF position.
C. When operating the remote control, it must be directed towards the front center
of the appliance.
D. The button at the top left of the remote can be used to power up or down the
appliance (the main power switch on the appliance must be in the ON position for
the remote to operate). Pressing this button activates the power to the appliance.
E. To activate fl ame, press the "FLAME" button and then to adjust the fl ame
height press the “ +5” or “ -5” buttons. There are fi ve levels of fl ame effects.
F. To activate the heater, press the "HEAT" button. The initial set-up heat level
will be set for high heat, to adjust the heat level choose the button for high
heat (1500W) or button for low heat (750W). Adjusting to auto control by room
temperature press the "ROOM TEMP" button, the heater turns on when room
temperature is below 21°C. the heater will turn off when the room temperature is
above 25°C.
G. To adjust the blue fl ame press the “ +5” or “ -5” buttons. There are fi ve levels
of fl ame effects.
H. To turn off the appliance, press the button once.
NOTE: This remote control must remain within 8 meters or 26 feet of the appliance to be effective
and this range may be reduced as the battery power is depleted.
POWER
SWITCH
5.2 OPERATING BY REMOTE CONTROL
BOTTOM VIEW