Balboa Water Group Freedom Jets 10-FS715T - Manuel

40729 Rev A July 30, 2009
FREEDOM JET 10-FS711, 10-FS715, 10-FSB11T & 10-FS715T
Specifications
Body: White PVC
Wall fitting White ABS
Recommended hole sizes: 2 5/8”
Recommended flow rates
10-FS711/10-FS715: 3 m 3 /h @ 9 m H
2
O
10-FSB11T/10-FS715T: 1.5 m 3 /h @ 7 m H
2
O
Dimensions
10-FS711/10-FSB11T: 32 mm ID air x 32 mm ID water. Drainable
10-FS715/10-FS715T: 32 mm ID air x 50 mm ID water. Non-drainable
Important
Follow the directions for installation and connection. We reserve the right to change the product and the
manual without notice.
Installation
1. Before drilling the 2 5/8” holes to install the jets, make sure the surface is flat so the wall fitting will
have the best surface to seal against.
2. The gasket can be placed on the inside or outside surface of the radius. It may be necessary to in-
stall the gasket on the inside surface to obtain the best seal. Also if the gasket is to be placed on the
outside surface, make sure the surface is smooth enough to seal. A little silicone in both areas will
help the wall fitting and gasket.
3. Before inserting the wall fitting through the hole, use the silicone on the thread area of the wall fitting
only, filling the tread grooves. This will help seal the wall fitting and jet together.
CAUTION: DO NOT PUT SILICONE INSIDE THE JET AS THIS WILL INTERFERE WITH THE
OPERATION OF THE JET.
4. Using the wrench, tighten the wall fitting hand tight. It is not necessary to over-tighten the wall fitting
as the gasket and silicone will create a good seal.
5. After jets are installed on the spa, you can proceed to connect the plumbing. Be sure air lines are
placed in sockets marked “AIR” and water lines are placed in sockets marked “WATER”. Use care
when applying cement inside the slip sockets of the jets. I f you use too much cement, it may be
pushed down into the air and water ports causing interference of the jet operation.
6. Be sure air hoses do not sag. If air hoses sag, the jets may not aspirate properly. You may want to
insert the wall fitting loosely in the jet until all the plumbing is installed and then follow steps 2
through 6.
7. After running the spa for fifteen minutes to clean debris from water hoses, install the directional eye-
ball, adjustable eyeball or Micro’ssage assemblies.
TURN PUMP OFF PRIOR TO INSTALLING OR CHANGING THERAPY OPTIONS.
Note
Use of an air pump to boost the jets is not recommended. The Freedom series is designed to operate
with maximum efficiency without the use of an air pump.
49-10-FS711CEC
ITT HydroAir, February 2006