Sony MDS-JE320 - Manuel (Page 7)

Basic Operations
Basic Operations
7 EN
5 Press r REC.
The deck becomes ready to record.
6 When recording the analog input signal, adjust the recording
level with REC LEVEL.
The fourth dot is satisfactory for most purposes. For details,
refer to “Adjusting the Recording Level” on page 11.
7 Press · or P.
Recording starts.
8 Start playing the program source.
Do not disconnect the deck from the power source immediately after
recording
If you pull out the AC power cord during recording or while “TOC” flashes in
the display, “STANDBY” flashes in the display when you turn on the deck
next and the recorded material may not be saved correctly to the MD. To save
the material, after recording, press § EJECT to take out the MD or change the
deck to standby by pressing 1 /u. “TOC” will flash in the display at this time.
After “TOC” stops flashing and goes out, you can pull out the AC power
cord.
To Press
Stop recording p
Pause recording* P. Press the button again or press · to resume
recording.
Take out the MD § EJECT after stopping.
* Whenever you pause recording, the track number increases by one. For example, if
you paused recording while recording on track 4, the track number increases by
one and recording continues on the new track when restarted.
To protect an MD against accidental erasure
To make it impossible to record on an MD, slide the tab in the direction of
arrow, opening the slot. To allow recording, close the slot.
When ”TOC“ flashes in the display
The deck is currently updating the
Table Of Contents (TOC).Do not
move the deck or pull out the AC
power cord. Changes to an MD
made through recording are saved
only when you update the TOC by
ejecting the MD or changing the
deck to standby by pressing the
1 /u switch.
Rear of the disc
Record-protect tab
Slide the tab in the
direction of arrow