Sony TA-N1 - Manuel (Page 7)

7 GB
Hooking Up the Components
1
1 2
3
2
CONNECTION
ASSIGNMENT
BALANCED INPUT SELECTOR
IMPEDANCE USE 4~16 Ω
L
L
+
+
–
–
R
R
–
–
+
+
BALANCED UNBALANCED
L
L
R
R UNBALANCED 1 2
1 : GROUND
2 : HOT(+)
3 : COLD(–)
INPUT
SPEAKERS
A + B USE 8~16 Ω
–A–
–B–
Speaker Hookups (Standard Connections)
Connect the jacks on the speakers to the SPEAKERS A or
B terminals on the power amplifier using a single speaker
cord for each speaker. There is no difference in the sound
output from SPEAKERS A and B. For details, refer to the
instructions supplied with the speakers.
Connecting the speaker cords
Caution
This is a high output amplifier. Touching the stripped
end of the speaker cords when the power is on may
result in injury.
• Be sure to check that the amplifier is turned off before
making any connections.
• Strip both ends of the speaker cords about 10 mm
( 3 / 8 in.) and twist the wire strands of the cord together
(A).
• Insert each end of the speaker cord fully into the
speaker terminal.
Be sure the stripped portion of the speaker cord does
not protrude outside of the speaker terminal cover
(USA/Canada only) nor from the speaker terminal (B).
Required cords
Speaker cords (1 pair) (not supplied)
Connect the jacks on the speaker to the power amplifier’s
SPEAKERS A or B terminals.
Notes on speaker hookup
• Connect the right speaker to the “R” terminals, and
connect the left speaker to the “L” terminals.
• Be sure to match the ends of the speaker cord to the
appropriate terminal on the components: + to + and –
to –. If the cords are reversed, the sound will be
distorted and will lack bass.
• When the maximum input level of the speakers you are
using is low, try to avoid excessive power output from
this unit to the speakers by controlling the volume on
the preamplifier. Continuously playing an audio source
at a level that distorts the audio output may damage the
speakers.
• The speaker terminals on this unit are compatible with
Y lug jack connection (European model only).
10 mm
(
3 / 8 in.)
speaker cord
A B
(Speaker terminal cover is
on USA/Canadian models
only.)