Sony STR-DA4300ES - Manuel (Page 45)

45 GB
F:\Sony\_DA4300\_DTP\3209655111\3209655111STRDA4300ESUC\01GB-
STRDA4300ESUC\030CON.fm masterpage: Right
STR-DA4300ES
3-209-655-11(1)
G
e
tting Star
te
d
Notes
• The auto calibration function does not work if
headphones are connected.
• Cancel MUTING if it is set to on.
1
Connect the supplied optimizer
microphone to the AUTO CAL
MIC jack.
2
Set up the optimizer
microphone.
Place the optimizer microphone at your
seating position. Use a stool or tripod so
that the optimizer microphone remains at
the same height as your ears.
On setting up the active sub
woofer
• When a sub woofer is connected, turn on the
sub woofer and turn up the volume
beforehand. Turn the MASTER VOLUME
knob to just before the mid-point.
• If you connect a sub woofer with the
crossover frequency function, set the value
to maximum.
• If you connect a sub woofer with an auto
standby function, set it to off (deactivated).
Note
Depending on the characteristics of the sub woofer
you are using, the setup distance value may be
further away from the actual position.
Using the receiver as a pre-
amplifier
You can use the auto calibration function when
you use the receiver as a pre-amplifier.
In this case, the distance value shown on the
display may differ from the actual distance
value. However, there will be no problems
even if you continue to use the receiver with
that value.
The auto calibration function allows you to
measure the following:
• Speaker connections
a)
• Polarity of speakers
• Speaker distance
b)
• Speaker size
b)
• Speaker level
• Frequency characteristics
c)
Optimizer microphone
Performing auto calibration
continued