Sony CDX-GT820IP - Manuel (Page 15)

15
Other functions
Changing the sound settings
Adjusting the sound
characteristics
1
Press the select button.
2
Rotate the control dial until the
desired menu item appears, then
press the select button.
3
Rotate the control dial to select the
setting, then press the select button.
The setting is complete.
After 3 seconds, the setting is complete and
the display returns to normal play/reception
mode.
The following items can be set (follow the page
reference for details):
“
z
” indicates the default settings.
*1 When tuner is selected as the source, the default
setting is “off.”
*2 When AUX source is activated.
Customizing the equalizer curve
— EQ3 Tune
“Custom” of EQ3 allows you to make your own
equalizer settings.
1
Select a source, then press the select
button.
2
Rotate the control dial to select “EQ3
parametric,” then press the select
button.
3
Rotate the control dial to select
“Custom,” then press (SEEK) +.
4
Rotate the control dial to select “EQ3
Mode Tune,” then press the select
button.
5
Rotate the control dial to select the
desired frequency range from “LOW,”
“MID” or “HI,” then press the select
button.
6
Rotate the control dial to select the
center frequency you wish to adjust,
then press the select button.
Selectable frequency in each range:
LOW: 60 Hz or 100 Hz
MID: 500 Hz or 1.0 kHz
HI: 10.0 kHz or 12.5 kHz
7
Rotate the control dial to adjust the
equalizer curve.
The volume level is adjustable in 1 dB steps,
from –10 dB to +10 dB.
8
Press the select button.
Repeat steps 5 to 8 to adjust other frequency
ranges.
9
Press (BACK) or (SEEK) – twice.
The display returns to normal play/reception
mode.
To restore the factory-set equalizer curve,
select “EQ3 Mode Initialize” and “Yes” in
step 4.
Tip
Other equalizer types are also adjustable.
EQ3 parametric
To select an equalizer type: “Xplod” (
z
),
“Vocal,” “Edge,” “Cruise,” “Space,” “Gravity,”
“Custom” or “off.”
DSO* 1
To select the DSO mode: “1,” “2” (
z
), “3” or
“off.” The larger the number, the more enhanced
the effect.
Balance
To adjust the balance between the right and left
speakers: “R10” – “0” (
z
) – “L10”
Fader
To adjust the balance between the front and rear
speakers: “F10” – “0” (
z
) – “R10”
Subwoofer
To adjust the subwoofer volume: “+10” – “0”
(
z
) – “–10”
(“–
∞” is displayed at the lowest setting.)
LPF (Low Pass Filter)
To select the subwoofer cut-off frequency: “off”
(
z
), “125Hz” or “78Hz.”
AUX Level* 2
To adjust the volume level for each connected
auxiliary equipment. This setting negates the
need to adjust the volume level between sources
(page 17).
Adjustable level: “+18dB” – “0dB” (
z
) –
“–8dB”