Placing the camera on the cyber-shot station, Removing the camera from the cyber-shot station, Charging the battery pack – Sony CSS-PC1 Manuel d'utilisation

Page 12: 1-gb

Advertising
background image

1-GB

Placing the camera on the 

Cyber-shot Station 

Remove the Adaptor ring, the Conversion lens, 

etc. from the camera.

Attach the camera as shown below.

Insert the “Memory Stick Duo” into the camera.

When you use data in the internal memory,

do not insert the “Memory Stick Duo” into the

camera.

Be sure to turn off the camera before placing it on

or removing it from the Cyber-shot Station.

Tips

You can attach the camera to the Cyber-shot

Station smoothly by aligning the camera to the

right corner of the Cyber-shot Station.

Make sure that the camera is securely attached to

the Cyber-shot Station.

Removing the camera from 

the Cyber-shot Station 

Hold the Cyber-shot Station down when you

remove the camera from the Cyber-shot Station.

Notes

When removing the camera, make sure to lift the

camera straight up. It may damage the camera or

the Cyber-shot Station when some extra is added

to the front or the sides.

Charging the battery pack

Place the camera with the battery pack 

inserted on the Cyber-shot Station.

Charging starts automatically. The CHARGE lamp

of the Cyber-shot Station lights up.

When the camera is turned on, the Cyber-shot

Station stops charging the battery pack.

When the charging reaches to Normal charge*,

the CHARGE lamp goes off.

Recording and playback time with Normal

charge is approximately 90% of Full charge.

For the time of the full-charge for a completely

discharged battery at the temperature of 25 °C

(77 °F), see the table below.

DSC-T100, DSC-T25, DSC-T20,

DSC-W200, DSC-W90,

DSC-W85, DSC-W80

Approx.

230 minutes

It may take longer to charge, depending on the

charging condition and environment.

If CHARGE lamp fails to light or blinks for more

than 10 seconds, refer to “Troubleshooting”.

Notes

After attaching the camera to the Cyber-shot

Station, the CHARGE lamp may blink for 3 to 10

seconds. This indicates communication between

the camera and the Cyber-shot Station, and it is

not a malfunction.

Charging temperature

The temperature range for charging is 0 °C to

40 °C (32 °F to 104 °F). However, to provide

maximum battery efficiency, the recommended

temperature range when charging is 10 °C to

30 °C (50 °F to 86 °F).

On battery life

The battery life is limited. Battery capacity

decreases little by little as you use it more and

more, and as time passes. If the battery operating

time seems shortened considerably, a probable

cause is that the battery pack has reached the end

of its life. Buy a new battery pack.

The battery life varies according to how it

is stored and the operating conditions and

environment in which each battery pack is used.

*

Advertising