Sony KDL-40R350B - Manuel (Page 7)

7 US
US
Setting Up Your TV
Some TV models are packaged with a detached
Table-Top Stand so you can mount your TV to a wall
right away. If you are not mounting the TV to a wall,
you will need to attach the Table-Top Stand. You will
need a Phillips screwdriver (not supplied) and the
supplied screws to complete the task. Look for the
supplied Table-Top Stand instruction leaflet.
Be sure to consider the following while setting up
your TV:
 Disconnect all cables when carrying the TV.
 Carry the TV with the adequate number of
people; larger size TVs require two or more
people.
 Correct hand placement while carrying the TV is
very important for safety and to avoid damage.
 Do not put stress on the LCD panel or the frame
around the screen.
 Ensure your TV has adequate ventilation, see
page 28.
 For best picture quality, do not expose the screen
to direct illumination or sunlight.
 Avoid installing the TV in a room with reflective
wall and floor materials.
 Avoid moving the TV from a cold area to a warm
area. Sudden room temperature changes may
cause moisture condensation. This may cause the
TV to show poor picture and/or poor color. Should
this occur, allow moisture to evaporate
completely before powering the TV on.
 Ensure that there are no objects in front of the TV.
Attaching the Table-Top Stand
Note
• If using an electric screwdriver, set the tightening torque
at approximately 1.2N·m {12kgf·cm}.
• When detaching the Table-Top Stand, reverse the
attaching procedure.
• Be sure the TV is vertical before turning on. To avoid
uneven picture uniformity do not power on the TV with
the LCD panel facing down.
• When attaching the Table-Top Stand again, be sure to
fasten the screws (previously removed) to the original
holes on the rear of the TV.
KDL-40R350B
IR Sensor